• Yellow wire - connect to ignition switch so that power is off when switch is turned off
• Orange wire - connect to water temp light sender included (to be installed on the motor)
• Green wire (3 & 4 gauge panels) - connect to oil temp light sender included (to be installed on the motor or in the oiling system)

Be sure that the panel is grounded to the frame. This is normally accomplished by mounting it. However, if it is mounted in a fiberglass or non-conductive dash, a separate wire will need to be run to ground.

Warning Light Settings:

• Oil Pressure - 20 psi
• Water Temp - 230 degrees
• Oil Temp - 270 degrees
• Fuel Pressure - 4 psi & adjustable