Using the enclosed cable connect the remote box to the tach at the back (remove the black rubber protector on the tach). Don't over-tighten the screws.

Cut the orange wire loop on the tach main harness. Wrap electrical tape around the bare ends to prevent shorts. If you disconnect and stop using the remote control you will need to reconnect this orange wire loop for the tach to function.

• To run set blue knob to "Tach"
• To show memory move blue knob to "Recall". Set it back to "Tach" to run again.
• To clear memory push green "Reset" button.

Optional High RPM warning lite / shift lite: Lite is connected to back of tach using the gray wire with white connector. You can also use another lite by cutting off the white connector. Set by turning blue knob to "Lite Set". Use small screw driver to adjust setting at "Hi RPM Warning Lite and Shift Lite Setting". RPM setting will show on tach. Turn back to "Tach" to run.